• (168) inches long (96) inches wide
• (0.1644) inch steel floor with oil resistant non-slip flooring
• Full width formed steel crossmembers on (12-16) inch centers
• Full length (8) inch x (3) inch rectangular steel tubing
• Gussets located at each crossmember and long sill contact point
• Side rails full length (4) inch x (2) inch rectangular steel tubing

• Formed steel construction with integral drip ledge
• Reel mounting; Heavy duty multi-level with sloped bottom drip tray and drain plug
• Rear access; Aluminum shutter eye overhead roll-up door with counterbalance spring
• Interior lighting; (12) VDC LED strip lights installed in hose reel area

Fuel Tank - Modified Elliptical Design

• Large radii shell with dished and flanged heads
• Tank is built to DOT-406 specifications but not certified
• (1000) U.S. gallons single compartment
• (0.1644) inch high strength low alloy tank heads
• (0.1644) inch high strength low alloy baffle(s)
• (0.1644) inch high strength low alloy bulk heads
• (0.1644) inch high strength low alloy tank shell

• (1) each (120) U.S. gallon used oil tank
• (4) each (60) U.S. gallon oil tanks
• (1) each (55) U.S. gallon "A/F" tank - poly construction
• (1) each (55) U.S. gallon "DEF" tank - poly construction
• (1) each drum nest and hold down kit for a (120) lb. commercial drum
• Large radius formed corners to reduce stress concentrations. Tank corners are "double wall" construction
• Material; High strength low alloy formed steel for petroleum products. Poly construction with steel frame for anti-freeze
• Mounting; Structural angles
• Interior cross baffle
• Fill port; (4.00) inch nominal diameter non-vented lockable fill lid
• Vent; (10) micron atmospheric vent on oil tanks
• (3) liquid level sight eyes each tank. (None in fuel or poly tanks)